Re: SKarosser Copy Scratch Home build?????
Posted: February 12th, 2019, 3:27 pm
Moving along slowly
All the PVC sheets were removed.
Aluminium building tape used to tape across all the spars to seal between primary insulation and the spars.
With all the joints in the bedroom sealed a layer of foil bubble wrap insulation was then fixed over the whole area and again sealed to ensure no air gaps to allow condensation.
With, what I hope is virtually an air tight walling, the PVC sheets are having the van carpet glued to them and then screwed into place. Trying to hold it in place and fit the screws in position proved a little challenging It finished up like working in a mine shaft with the props holding in position.
The slight overlap should allow a neat corner arrangement
Also while I had the camera out He is one of the rough build of the final gas box and cupboard front
All the PVC sheets were removed.
Aluminium building tape used to tape across all the spars to seal between primary insulation and the spars.
With all the joints in the bedroom sealed a layer of foil bubble wrap insulation was then fixed over the whole area and again sealed to ensure no air gaps to allow condensation.
With, what I hope is virtually an air tight walling, the PVC sheets are having the van carpet glued to them and then screwed into place. Trying to hold it in place and fit the screws in position proved a little challenging It finished up like working in a mine shaft with the props holding in position.
The slight overlap should allow a neat corner arrangement
Also while I had the camera out He is one of the rough build of the final gas box and cupboard front